Yours looks like alot of work too.Luckily you have a shop , not like me <img src="/forums/images/graemlins/nana.gif" alt="" /> Most of the frame I have is solid , except for the gussets and back crossmember.Those seem to be a bad spot for rust on all troopers.Wait untill you see the bad frame with the body off <img src="/forums/images/graemlins/scared.gif" alt="" /> A little cutting and welding on this one , some rustproofing and paint , it will look as good as new <img src="/forums/images/graemlins/kewl.gif" alt="" /> I just need to get rid of this 4 cyl engine and tranny , then I can dig in on the frame.I have no idea where to put the extra engines and stuff I have , might have to rearange the back shop , take the boat out of there.The motor bike is staying though <img src="/forums/images/graemlins/smile.gif" alt="" />

So much work to go yet , but its slowly getting there now that I have officialy started the big project.I am still shooting for the end of March , or very shortly after.Once the frame is done , then I'll start putting in the new brake lines and my custom fuel system.I might raise my tank up just a little too as I have to make a custom mount for it as its a 19 gallon fuel cell.All my lines are stainless braided , with russell fittings everywhere.No push on lines at all , other than the main fill hose , all the others are screw on , even the filters.New tie rods , torsion bars , ball joints , new bushings for the rear end , new rad , built up 3.4 , tera lows , front lock rite , headers , I am going all out on this one <img src="/forums/images/graemlins/kewl.gif" alt="" />