Well , the front end is pretty much done now , just need the tie rods and shocks put on , all the hub , rotors , calipers , ball joints , control arms are on.I think there is something I didn't do with the torsion bars though , I can turn the big bolt(27MM) by hand untill it gets tight to hold the round part in the groove , but the bolt is sticking out almost all the way.I know when I adjusted the bars on the truck before , it was sticking out a little bit only , maybe 1/2" or so , and by the time I was done it was maybe a little over an inch sticking out the back.Right now on one side its sticking out at least 2" , maybe closer to 2 1/2 , and the other side is close to 2" before it got tight enough to hold the bracket.

Anyone have any ideas what I might have done wrong?In the instructions it says to index the bars , but thats because your not taking everything off , just the bars out.With me , everything was off , even the control arms.So , I just put it back together how it was , but it doesn't seem like there is any tension on the bars? <img src="/forums/images/graemlins/confused.gif" alt="" />