Ok , as promised here are a few pics.They would have been up earlier , but my internet connection went out on me <img src="/forums/images/graemlins/evil.gif" alt="" />I pick up my fuel cell stuff today , so will have a good idea of where I will mount it exactly for height wise , then I can run the lines to the tank itself.I left the lines a little long off the engine as I am not 100% sure how I want to run them down the engine yet.Also I will get my tranny corssmember done tomorow so I can mount that properly.Oh , by the way , those fittings aren't the easiest thing to put on stainless braided hose <img src="/forums/images/graemlins/nana.gif" alt="" /> The hose only stretches so far , so where it went on the water pump , I had to rig up a little adapter for it so it would work.


















I tried to get pics of every angle to show all the stuff on the engine.The last picture is where my lines will connect at the firewall area.One is just a connector to join the hoses , while the other one is an edelbrock fuel filter.I will have another one by the pump also.I just thought it would be better to have another one closer to the TB to pick up any extra stuff that gets through the first filter.The other one will go between the tank and the pump , just haven't looked at where the pump is going to go exactly yet.Still a little figuring to do.Pretty much all thats left on the engine is to finish mounting the headers on(just tacked on for now) and put the belt on , and the rad.All the wires are on and plugged in , and all the hoses are on.

Once I get the tranny crossmember done , then I will put the new seals in , and mount that down.I still have to get the shift rail extended for the lift.Sometime this week I will start transfering the tera stuff into the other transfer case and get that all done. <img src="/forums/images/graemlins/kewl.gif" alt="" />