Well , got the fuel cell all fixed up , and the fuel hose on , had to splice it with old hose and new hose as the filler neck on the truck is bigger than the other end of the hose <img src="/forums/images/graemlins/angry.gif" alt="" />
Anyway , thats all done.I also have the back pucks on , the 4 skinny ones.I was then going to put the middle ones on where they go through the top , but it seems the stock pads are too thick on the bottom.When I put the bolt through , there isn't enough thread to even start the nut.But on the back , they fit fine , with even an inch of thread to spare.Not sure whats up with that , these are the new ones Jerry sent me , part sits on the top of the frame , and a pin goes through the rubber piece and joins through the bottom of the frame.But the bottom piece is like 2" think , plus you add in the top part is 1" , and the lift puck , 3" , thats 6" right there.I think the bolts are just 7".Also add in the frame part and the washer , your almost at 7" there.Maybe I might have to cut some of the rubber down to make it work , and also a part of that pin.I can't really see any other way for the other pucks to fit otherwise.Maybe tomorow I'll actualy have some time to work on it , stupid late truck at work , making my days over 12 hours , no time to play
<img src="/forums/images/graemlins/scared.gif" alt="" />