Been searching around for a while on different things and noticed that a lot of people have issues with getting the cap on/off the 2.6. Bought a new cap and rotor today and decided I'd give it a go. Now I know what ya'll are talking about! <img src="/forums/images/graemlins/shiner.gif" alt="" />

But, instead of struggling for a long while, I got out my trusty UNIT skate tool (see, skateboarding ISN'T a crime!), whipped out the little angled screwdriver that comes in it and viola! It's the perfect length to reach the screws and just clear the top of the cap. And since it's angled like an allen wrench, I had plenty of leverage to loosen/tighten the screws.
Tool!

10 minutes and I was done.


Now the question. Aparently I snagged something loose when I did the cap, cause now I'm getting a code 34 (MAP Sensor). Anyone have any recommendations on where to look? I'm at work, so I haven't investigated further than pulling the code...