Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 2 1 2
lubricate #701526 03/01/06 01:34 AM
Joined: Feb 2006
Posts: 77
H
Hal2000 Offline OP
Getting the Wheeling Fever
I was just reading the owners manual and saw that I need to lubricate the hinges and other parts and was wondering what do y'all use?


98 Sportage
Re: lubricate [Re: Hal2000] #701527 03/01/06 02:19 AM
Joined: Mar 2002
Posts: 4,497
Axe Man Offline
Kia Moderator Emeritus
White lithium grease in a spray can.


1998 Sportage - Gone.
2004 Honda Civic Coupe.
2007 Suzuki Grand Vitara - She got it.
Re: lubricate [Re: Axe Man] #701528 03/01/06 02:24 AM
Joined: Feb 2006
Posts: 77
H
Hal2000 Offline OP
Getting the Wheeling Fever
tnx axe man.. now if I could just figure out what is squeaking in the front passanger side..


98 Sportage
Re: lubricate [Re: Hal2000] #701529 03/01/06 02:29 AM
Joined: Mar 2002
Posts: 4,497
Axe Man Offline
Kia Moderator Emeritus
Quote
tnx axe man.. now if I could just figure out what is squeaking in the front passanger side..


Is the squeak in the front suspension? If yes you might have a bad lower ball joint. They start squeaking when worn out.


1998 Sportage - Gone.
2004 Honda Civic Coupe.
2007 Suzuki Grand Vitara - She got it.
Re: lubricate [Re: Axe Man] #701530 03/01/06 04:23 AM
Joined: Feb 2006
Posts: 77
H
Hal2000 Offline OP
Getting the Wheeling Fever
As far as I can tell its in the front somewhere near the tire.
If I push down or pull up on the front passenger side it will squeak


98 Sportage
Re: lubricate [Re: Hal2000] #701531 03/01/06 05:30 AM
Joined: Feb 2006
Posts: 77
H
Hal2000 Offline OP
Getting the Wheeling Fever
If it is the lower ball joints how hard is it to replace them?
I've never had to replace any before.


98 Sportage
Re: lubricate [Re: Hal2000] #701532 03/01/06 01:40 PM
Joined: Mar 2002
Posts: 4,497
Axe Man Offline
Kia Moderator Emeritus
Quote
If it is the lower ball joints how hard is it to replace them?
I've never had to replace any before.


The lower ball joint is held in by 4 bolts then tend to break off when you try to remove them. Least source of aggravation is to have a shop do the work.


1998 Sportage - Gone.
2004 Honda Civic Coupe.
2007 Suzuki Grand Vitara - She got it.
Re: lubricate [Re: Axe Man] #701533 03/02/06 08:22 AM
Joined: Aug 2002
Posts: 1,136
Nukeiridium Offline
Body Damage is Cool
Quote
The lower ball joint is held in by 4 bolts then tend to break off when you try to remove them.


Hmm... spray with PB blaster, let soak overnight, then use an impact wrench... I bet they would cooperate smile


2002 Sportage 4dr 4x4 soon to undergo an Extreme Makeover!
Re: lubricate [Re: Axe Man] #701534 03/07/06 04:47 AM
Joined: Feb 2006
Posts: 77
H
Hal2000 Offline OP
Getting the Wheeling Fever
You were right Axe. I had someone take a look at the lower ball joint and the boot is torn. So its going to get replaced this weekend..
This is off subject but do any of you use the K&N air filter? The guy whos doing the ball joint replacement told me that he changed his filter with one of these and he noticed a big difference in HP.. He builds and repair race cars out here.
Do they works like he's talking about or is it just a waste of money?


98 Sportage
Re: lubricate [Re: Hal2000] #701535 03/07/06 01:42 PM
Joined: Mar 2002
Posts: 4,497
Axe Man Offline
Kia Moderator Emeritus
IMHO K&N Filters are a waste of money. And that statement is supported by this crew here...

http://bobistheoilguy.com/

Plus, if you put too much oil in them the mass airflow sensor gets contaminated with oil.


1998 Sportage - Gone.
2004 Honda Civic Coupe.
2007 Suzuki Grand Vitara - She got it.
Page 1 of 2 1 2

Moderated by  4x4Wire, Axe Man, DamKia 







4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.008s Queries: 16 (0.005s) Memory: 0.6328 MB (Peak: 0.7401 MB) Data Comp: Off Server Time: 2026-10-24 07:49:28 UTC
Valid HTML 5 and Valid CSS