How to align flywheel and torque converter?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: How to align flywheel and torque converter? [Re: a1966f100] #704646 03/10/06 03:23 PM

Joined: Jan 2006

Posts: 10

Charlotte,NC

a1966f100

Need a Spot

Got it! Once I got my arm contorted enough to get my hand into the starter hole I realized the flywheel and converter were turning together. The crank had been replaced in the rebuild and I had failed to check the fit between the "pilot" dia on the converter and the crankshaft. So out with the engine and a little polishing on the crank c'bore and then the torque converter lined up easily. Thanks!

19644speed

Entire Thread
Subject	Posted By	Posted
How to align flywheel and torque converter?	a1966f100	03/09/06 02:19 PM
Re: How to align flywheel and torque converter?	Madcat	03/09/06 02:47 PM
Re: How to align flywheel and torque converter?	JLEMOND	03/09/06 11:19 PM
Re: How to align flywheel and torque converter?	a1966f100	03/10/06 03:23 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.454s Queries: 16 (3.451s) Memory: 0.5974 MB (Peak: 0.6303 MB) Data Comp: Off Server Time: 2026-06-20 03:48:32 UTC
Valid HTML 5 and Valid CSS