When I was taking my knuckle off I knew the bearing was not going to look good when I found this.
[Linked Image]
I was correct because later I found this.
[Linked Image]
Then when I was done beating the <img src="/forums/images/graemlins/evil.gif" alt="" /> out of the bearing trace this is what I ended up with.
[Linked Image]
When I finally get to the other side I will just have a machine shop take them out before pressing in my new bearing. Also notice in the last pic I found a new tanning method. <img src="/forums/images/graemlins/barf.gif" alt="" />

89 2dr 3.0 AT, manual hubs. 33x12.5 MT
gen 2 coils,Cranked front tbars
Dons rocker protection, Front/Rear Bumpers. ARB rear locker, 2" BL, Beefed up skid plates/trailing arms. Gen II uca, 2 Bouncy seats www.youtube.com/TagGeorge