Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
Code 14, Igniter probs #709553 03/24/06 07:13 AM
Joined: Jan 2006
Posts: 32
Jickle Offline OP
Getting the Wheeling Fever
I own a 92 pickup, 203k , v6, xtra cab auto.

The check light did not come on, just when I jumped the connectors. I got a code 14 when not running and running.

I read in the forums to check the voltage between E1 and Ig connectors and I got a 13.5v reading. (It should be between 0.7 and 1.0 v I believe)
I then checked the specs on the igniter and found out something interesting. I tested the igniter about 20-30 minutes after driving the truck and it says the ohm should be within .45 - .66 ohms when hot. Cold was like .33 - .55ohm I was getting a fluctuation between 0.4 to 0.9 ohm and even 1.0 once. WHAT THE HECK ? Should I replace the igniter?

The engine runs fine, except for a slight hesitation when starting. There is a slight variance in the rpm when idling. What should I do, the voltage is WAY off of what is should be. The engine has never stalled on me.

Thanks ahead of time !


stock 92 pickup, v6, xtra cab, 4x4 IFS, 204k miles
Re: Code 14, Igniter probs [Re: Jickle] #709554 03/24/06 09:03 AM
Anonymous
Unregistered
The increased resistance shows the effects of heat on the coil. Try resetting the CEL by pulling the EFI fuse or disconnecting the negative battery terminal for about 10 minutes. It mayhave been a false code.

The surging at idle may be a small vacuum leak or the TPS a little out of adjustment ( or not working properly).

Mike in AR


Moderated by  4Crawler, 4x4Wire, kewlynx 







4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.010s Queries: 15 (0.007s) Memory: 0.5850 MB (Peak: 0.6347 MB) Data Comp: Off Server Time: 2026-11-16 01:30:07 UTC
Valid HTML 5 and Valid CSS