Thanks CORunner. That is what I needed to know! I think I wil try to drill out the thing on the TB instead though - sounds easier!!

Do you have a rear heater? Did you manage to get the heater hoses and the throttle cable to fit b/w the engine and firewall? It looks a little tight on mine....

Quote
Don't know if you have looked at other posts on this or any writeups but you will need to use the oil pan from your old 3.0, because it is shaped to fit around your front diff. The 3.4 is shaped opposite to yours because on the new tacoma/runner the diff is on the drivers side.


Not only have I looked at a few other posts, I already have the engine in the truck, wired, and am at the point where I am trying to hook up the throttle cable ;-P

CAZ

Last edited by CAZ; 05/11/06 07:54 PM.
Email - mailto:caz@4x4wire.com
Web Page - www.andrewzook.com
My 40 Build