I am going to replace my rusty Left front axle with a better one from Calif. Don't I neeed to loosen a ball joint to get the spindle to pivot more to get clearance to remove the axle?
Do I loosen/remove the upper or lower ball joint? Don't I also need to remove the outer tie rod end?
I just replaced the right side axle. I was pleased with the wear of the needle bearing I had replaced with a tube of delrin.
If I use a lift, do I need to loosen the torsion bar too.
The needle bearings only hold up for 2 years. The delrin was worn but still acceptable after 6-7 years of use.
Thanks for the help in advance. <img src="/forums/images/graemlins/confused.gif" alt="" />