Ok , I put the front tires on today to see how it sits , looks great , but I noticed a problem right away.When I bounced the front end up and down , the driver side tire was going all over the place.I took the tire off and inspected the hub.I can push and pull on it , and it moves in and out about 1/4" or so , maybe a little more , which when you put a 33" tire on looks pretty bad.Now , I did everything back how it goes , tightened to spec with a torque wrench , and all the ball joints are brand new , so are the tie rods , and pretty much everything else in there.Now , could the tie rods , or lack of pressure in the brake system cause this at all?The other side seems fine , just a hair of play , can hardly notice it.

One other thing that comes to mind , when I put the outer bearing and outer race in , I couldn't remember how it went in.Could it be possible I put it in wrong , or will it only go in one way?I can't even remember if I put it tapered side in or out <img src="/forums/images/graemlins/scared.gif" alt="" /> If no one has any ideas what this could be , I might tearit apart again and try reversing the bearing and race.Anyone with any ideas , no matter what , toss them out there <img src="/forums/images/graemlins/smile.gif" alt="" />