halfway into aisin install - help

Print Thread

Rate Thread

Re: halfway into aisin install - help [Re: Shorts] #716492 04/21/06 01:44 AM

Joined: Sep 2004

Posts: 276

Pasadena, TX

NATO308

Mudrunner

Too much play for lack of shims will destroy the seal and needle bearing inside the back of the spindle and wear out the babbit bearing surface in the hubs.

'94, and '00 Amigos and '00, 01 Rodeos. Rodeo springs and aftermarket 'hard top on 94. Aisin hubs OME 919's on the 2000 Amigo. 2000 and 2001 Rodeos have OME 912's and Aisin. Smoother ride with the OME 919's???

Entire Thread
Subject	Posted By	Posted
halfway into aisin install - help	rodeoredd	04/17/06 06:05 PM
Re: halfway into aisin install - help	rodeoredd	04/17/06 07:57 PM
Re: halfway into aisin install - help	slappy	04/17/06 08:59 PM
Re: halfway into aisin install - help	ShowMeDave	04/17/06 10:28 PM
Re: halfway into aisin install - help	litnin	04/17/06 11:01 PM
Re: halfway into aisin install - help	rodeoredd	04/17/06 10:51 PM
Re: halfway into aisin install - help	rodeoredd	04/17/06 11:25 PM
Re: halfway into aisin install - help	Shorts	04/18/06 12:51 AM
Re: halfway into aisin install - help	TrooperJ	04/18/06 01:03 AM
Re: halfway into aisin install - help	Shorts	04/18/06 01:09 AM
Re: halfway into aisin install - help	rodeoredd	04/18/06 02:58 AM
Re: halfway into aisin install - help	Shorts	04/18/06 10:08 AM
Re: halfway into aisin install - help	NATO308	04/21/06 01:44 AM
Re: halfway into aisin install - help	rodeoredd	04/21/06 12:32 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social: