Homemade tube fenders

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Homemade tube fenders [Re: wyojeeper] #721789 05/08/06 03:22 PM

Joined: Dec 2005

Posts: 22

Cruizin

Need a Spot

You can make a jig that consists of tubes tack welded to a table. Then heat the tubing with a torch and bend it around the jig. Not going to be quick and easy but you will get better at it as you go.

I know smittybilt makes a fender like what you are describing.

Entire Thread
Subject	Posted By	Posted
Homemade tube fenders	wyojeeper	05/08/06 03:30 AM
Re: Homemade tube fenders	Anonymous	05/08/06 03:45 AM
Re: Homemade tube fenders	Anonymous	05/08/06 08:45 AM
Re: Homemade tube fenders	Cruizin	05/08/06 03:22 PM

Moderated by 4x4Wire

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.523s Queries: 16 (3.520s) Memory: 0.5971 MB (Peak: 0.6301 MB) Data Comp: Off Server Time: 2026-06-14 00:32:50 UTC
Valid HTML 5 and Valid CSS