You can get 1 3/4 inches of lift with TJ spring spacers. You'll have to get a 1 1/4 inch round cutter to make the center hole a little larger so it will fit in easily. They cost about 4o bucks a pair. For the body you can go with Calmini's 3" spacers, that's what I did, but you can also make your own from 3" square tubbing. Just cut the tubes 3" by 3". Drill two opposite holes. The top screw will fit through the top hole and you'll have to get an extra screw to fit in the bottom hole. For the front two holes you'll have to get a round tube of some type to fit the designated area. I know there is a site at www.zuwharrie.com/content/view/11/27/ This site has all the necessary information for the body lift. I wish I could post a picture for you, but I don't know how to load them up to the site. Still, look in Calmini in Tracker, and open the picture post on the left side of the screen and you'll get a good picture of lifted Trackers. I only envy the front bumper since it looks awesome, but costs about 450. Look into the rear limited slip, a must, and the lower skid plates, another must.