I just converted my 92 4runner a week and a half ago to 134a. My A/C was dead like yours and an R12 system. Here is what I did. Bought a new receiver/dryer, a package of green o-rings and a conversion kit that had three 15 oz bottles of 134a. Each bottle was 12 oz of 134a and 3 oz of Ester oil. I had this 4runner into Toyota 2 years ago on an expansion valve recall so I did not mess with changing it or the rings at the evaporator. I replaced the o-ring on the discharge line to the condenser, the two o-rings on the receiver/dryer and an o-ring on a connection to the lower left of the receiver. Basically, the four o-rings on the front of the 4runner. I borrowed a vacuum pump and set of gauges from a friend and pulled a vacuum on the system then let it sit for a hour to see if it held, and it did. Once I knew it did not have any leaks I let the vacuum run for about 30 or 40 minutes to purge the system. Charged the system up with 2 bottles of 134a and about 2 more oz from the third can for a total of 26 oz of 134a and 6 oz of oil. The system was blowing at 37 deg F when I stopped adding 134a. Not bad for an under a $100 convert. By the way I still have the same compressor and did not touch it. I did not feel like trying to pull it out and I thought if the system did not leak in the vacuum test why mess with it. Good luck.