Nope - still plenty of work left.... need to mark vacuum and boost port locations on the plenum and inlet pipe, weld some bosses at those locations so I can drill and tap for fittings, weld a rear support brace, fabricate the nose drive support, mount the fuel regulator, fabricate the intake flex hose, extend the wiring harness to the TPS and IAC, shorten the throttle and kickdown cables, send the blower back to Magnacharger for a replacement, install everything with plumbing, etc, make and install a hood scoop, paint the hood - and so forth.

Patience, grasshoppers - I only have a little time each week to work on this thing.

Frank