More like a post grad course - I may be referring to you as "Dr. Charlie" when this is done. <img src="/forums/images/graemlins/patriot.gif" alt="" />

I've used the table editor and table generator to set this up, but I'm not sure I did it correctly. In the generator, I guesstimated 7 psi boost pressure to create a 1.48 multiplier over OE specs (143HP @ 5000rpms/168lb-ft @ 2500rpms) and used the following values:

Displacement = 181.4 CI
Max Torque = estimated 250 lb-ft @ 2500 rpms
Max HP = estimated 210HP @ 5000 rpms

After editing the KPA and RPM bins, here's the generated table:



I don't yet fully understand the % table, but thought I'd run this up the flagpole to see if you'd salute it. <img src="/forums/images/graemlins/wink.gif" alt="" /> Will this work as a starting VE table or do I need to back up? Why are the VE % numbers below 100 in boost bins?

Frank