Quote
If you look at the V3 board with the 37 pin connector to your right, install the 450R from the left side of R12 to the lower position of R42 just above it. This will give you the +5V needed.


Should I remove R12 (390 ohm)? Remove R42(1K ohm)?

The new 450 ohm resistor should be 1/2 watt, right?

Frank

'89 [color:"white"]G-Raider[color:"white"] [color:"black"]Supercharged 3.0L, MegaSquirt 2, lockup A/T, 2.5" exhaust, 172k, Cibie H4s/Oscar SCs, Hella Micro DE fogs, Cobra CB, Superwinch hubs, LSD rear/Aussie Locker front, Bilsteins, Lifeline AGM, Rust-Oleum