|
|
|
|
HEI distributor wiring harness problems
#731541
06/15/06 08:59 PM
|
Joined: Dec 2005
Posts: 29
OP
Getting the Wheeling Fever
|
Got an HEI distributor on a 350. its on a boat, but lets pretend its in my jeep <img src="/forums/images/graemlins/wink.gif" alt="" /> the engine runs like crap, a noticable fuel or electric problem. While it was running I reach down to check the HEI wires that run from the cap into the distributor. As i touch them the engine gets worse. If i move them, the engine dies immediatly. The harness is cheap and doesnt fit tight into the cap. Is there an upgradeable harness, is this a common problem?
Thanks <img src="/forums/images/graemlins/scared.gif" alt="" />
86 CJ7, 258, MC2100 Carb, 4" Rough Country lift, 34" Swampers, Jeeperman bumper/tire carrier
|
|
Re: HEI distributor wiring harness problems
[Re: Thord]
#731542
06/15/06 11:27 PM
|
Joined: Oct 2003
Posts: 7,768
Web Wheeler
|
The harness should be almost water tight. Have you put some grunt into it! You may not have it all the way engaged. Big Jim <img src="/forums/images/graemlins/pfft.gif" alt="" />
professional bovine relocation specialist
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.005s Queries: 15 (0.003s) Memory: 0.5838 MB (Peak: 0.6318 MB) Data Comp: Off Server Time: 2026-05-26 12:20:10 UTCValid HTML 5 and Valid CSS