Quote
Hey bud, did u happen to measure those flanges before you installed it> I need to get some cut out of stainless but i dont want to take my exhaust off to measure them...


You may get your wish; I may be pulling them again soon...

The scoop: the heat transfer to the pass side floorpan is out of hand. I am worried I'd boil fuel or worse at slow speed wheeling. I whipped out a heat shield this morning, but I don't think it is enough. I really think I should have run the exhaust wrap righ up to the flange.

Any way, here are some pix of the setup mounted....

[Linked Image]

[Linked Image]

[Linked Image]

[Linked Image]


AJ
93 Toyota, dana 60, 14-bolt