ok.. good news and bad news...

Good news... I got both the Factory Manuals (and I guess I won't both to scan them then) and I got my two factory remotes...

It's very easy to program new units (in the BODY SECTION), on the remote computer in the back near the rear speaker, there's a "3way/position switch" thats labeled

"set-I / FIX / set-II" (upon looking at mine, it was always at set-I <img src="/forums/images/graemlins/lol.gif" alt="" /> )

anyways, get your remote, set the switch to "set-I" and click either the "LOCK" or "UNLOCK" ONCE!!.

Then set the switch to "FIX".. (but the factory manual doesn't tell you is you have to close all your doors to try it out), then repeat for remote #2 but set it to "set-II"

BAD NEWS is whenever I click the unlock button on the remote now, the doors unlook for a second or so, and then lock again. They go UP and then DOWN. I tried programming with all the doors in locked position, open, etc....

the factory manual doesn't show anything, no troubleshooting,etc... It didn't even say after you set the switch back and try the remote to make sure the DOORS ARE CLOSED OR THE LOCK SYSTEM WON'T WORK !!!!!

and it's 100* here right now and alittle hot so I had all the doors open. That took me abit to figure out.

any thoughts on why the locks "open and close" right away ?

thanks