puds- I'm doing my tranny temp gauge install now....this is something that you should have if you pull any kind of weight. It's really hot today....so hot....how hot is it?....hot enough to cause paint cans to "pop!!"....see pics....more to come soon.


I wanted more working room and also needed to clean the carpet....so I took some easy stuff out.....

.
.
.
That connector assembly near the flashlight is for the seat belt light that flashes too much.....

.
.
.
I cut it out....

.
.
.
It was real easy to remove the plastic console covers. It really was.

.
.
.
The purple and grey wires will go to the sensor that will screw into the tranny pan....I chose the rear right corner to run the wire thru a small slice in the rubber boot.

.
.
.
I drilled the pilot hole here....I probably should have drilled a little higher to make absolutely sure the sensor is in the oil bath.

.
.
.
I was in the process of touching up the tranny pan with some black paint.....it was hot in the garage and as I was shaking the can I heard this POP! and then saw this inverted bulge This happened "in the shade" <img src="/forums/images/graemlins/scared.gif" alt="" />