What are you using to test the accuracy of your clicker wrench? I used to have a beam type wrench to check it against, but it was stolen (sounds like the subject of a country music song: Ohhh, someone stole my torque wrench..). Any contraptions out there that you've built? Like a lever arm attached to weights, etc.?

I'm guessing that the adjustment is made by turning the set screw on the the ratchet arm. Is that right?

2000 Mitsubishi Montero Endeavor, "Katsumi", 138k
1993 Toyota Tercel, backup vehicle, 93k
1989 Isuzu Trooper, "Beniko", R.I.P. at 233k

My 'Genuine Isuzu Parts' decals - for sale