Usually there is a torque range instead of one specific value (not always though, IE IMG gaskets) so I normally set mine for the middle of the range. That way if its off a little (most likey) theres a good chance of being within range.

Anything under 20 ft lbs I use an inch lb wrench. More accurate at low values then a ft lb wrench.

Would like to get mine calibrated though.

--Dave

1999 Rodeo LS 3.2 4x4 5 Speed
32x11.50-15 BFG T/A KO on US Wheel 94 series
3" Lift - Rancho 9000x
Rear No-Slip Locker
Flowmaster 50 series SUV 2.25"

There is a very fine line between "hobby" and "mental illness." - Dave Barry