So I was putting in some 2" spacers today and living in Maine I was encountering some rust and such. All this week I had been spraying what I was going to work with with blaster and it did its job... until the last nut. As I was unbolting the final upper strut nut (toward the engine on the right, on the driver side) and about 4 threads from the top the bolt broke free and now the nut and bolt turn in unison. Not good. I installed the other side fine and I have everything ready except this one nut. How do I get this thing off? It seems that they should not be moving together and it is out of reach to clamp and unscrew. What do I do? Any help would be appreciated since now my vehicle is now on a tilt. (Also my sway bar nut snapped off with half the piece on the passenger side but this is not as serious. I was looking into getting sway bar disconnects anyway and I can drive it like that for a bit right?) Help!!