I was looking over the instruction set and am a little confused about something. It says I need to:
1)Remove the fulcrum pin
2)Use a press to remove the fulcrum pin bushings from the factory control arm and install into the new Calmini arm.
3) Install the fulcrum pivot pin through the eyelets of the calmini arm.
4) Install the bushing sleeves over the 2 pivot points
5) install the urethane bushings factory cup washer and nuts.

I assume that this means that I am going to re-use the factory fulcrum pin bushings. However, when I was calling around trying to find someone with a press locally, they told me that they would destroy at least one bushing trying to get it out and that I would be better off just getting new bushings. Is this true or am I just confused now?!