Quote
I want to try to stay away from the block's and my stock one's I got on this truck are actually litterally flat so...kinda why i was thinking of getting some leaf's custom arched, then putting some shock's in too for helping articulate/ride along with maybe a coil. Not so much worried as cheap, but dont wanna go spend thousands to do it ya know?


Re-arching stock springs is one thing, getting new springs custom built is another. If you can get some made to meet your needs, that is fine. I've run two different sets of custom built Alcan springs, they make them to meet your load and lift requirements:
- http://www.4crawler.com/4x4/4R_suspension-III.shtml#LongerRearSprings

They work way better than most anything you would get off the shelf. Here is a 3.5" lift spring setup (off the shelf), pretty much flexed out:
[Linked Image]

Here is the same 4Runner with some rear Alcans and stock rears up front:
[Linked Image]

[Linked Image]

r.c.brown@ieee.org
TruckEditor@tlca.org
Project: 4Crawler
4Crawler OffRoad - 4x4Wire discount code