Going from 3" body lift back to stock

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Going from 3" body lift back to stock #747112 08/25/06 12:59 AM

Joined: Aug 2006

Posts: 27

Vancouver, WA

SolidBlk85 Offline

Getting the Wheeling Fever

I just spoke to Toyota parts and to convert back to stock body height the body bushings cost $50 each x 6 = $300 !

This is basically a DD and I don't want to spend that much, does anyone have a cheaper route to get the cab back down? Seems the bed would be ok with just some rubber strips as bushings, but I would like a little cushion for the cab.

Any suggestions.....Thanks

Entire Thread
Subject	Posted By	Posted
Going from 3" body lift back to stock	SolidBlk85	08/25/06 12:59 AM
Re: Going from 3" body lift back to stock	RatLabGuy	08/25/06 01:40 AM
Re: Going from 3" body lift back to stock	Andy87	08/25/06 02:48 AM
Re: Going from 3" body lift back to stock	bkg	08/25/06 03:21 AM
Re: Going from 3" body lift back to stock	Snowtoy	08/25/06 04:45 AM
Re: Going from 3" body lift back to stock	4Crawler	08/25/06 06:12 AM
Re: Going from 3" body lift back to stock	SolidBlk85	08/25/06 07:23 AM
Re: Going from 3" body lift back to stock	4Crawler	08/25/06 07:30 AM
Re: Going from 3" body lift back to stock	Greg_Canada	08/25/06 01:53 PM
Re: Going from 3" body lift back to stock	SolidBlk85	08/25/06 09:59 PM
Re: Going from 3" body lift back to stock	Snowtoy	08/26/06 05:12 AM
Re: Going from 3" body lift back to stock	4Crawler	08/26/06 05:22 AM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social: