Gen I radiator compatability

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Gen I radiator compatability [Re: yankee7809] #748151 08/29/06 02:52 AM

Joined: Jan 2001

Posts: 13,649

Helen , GA

fasteddy

Web Wheeler

mounting bolt patterns are different, as are shroud mounting bolt positions. Swapping the side frames would make it work. I drilled out the two upper holes to match and zip tied the bottom until I get around to the frame swap.

Not responsible for advice not taken...

Entire Thread
Subject	Posted By	Posted
Gen I radiator compatability	yankee7809	08/28/06 04:41 PM
Re: Gen I radiator compatability	fasteddy	08/29/06 02:52 AM
Re: Gen I radiator compatability	yankee7809	08/29/06 06:06 PM
Re: Gen I radiator compatability	Oyaji_Jon	09/06/06 05:44 AM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 4.013s Queries: 16 (4.011s) Memory: 0.5992 MB (Peak: 0.6322 MB) Data Comp: Off Server Time: 2026-06-22 12:54:08 UTC
Valid HTML 5 and Valid CSS