Hey all I'm usally over at the Isuzu side of this site but the wife as the Jeep with the problem. I'm trying to get the front hub off to get the bearing removed and replaced. I did get the outer nut off with the 36mm size socket I needed but there are three bolts on the back side that I have never seen this type of bolt head. It looks like torx inside out or something. I would like to know what it is and what size so I can get the socket to get the thing off. My plan is to take the hub and have the bear removed and have another one pressed in. Is there anything else I should look for in this process cause I have never been into anything on this vehical yet. Thanks for any information you can give me and sooner the better cause I had to take off work to get this thing on the road again.

Carl

Oh yea It's a '99 Jeep Wrangler with the straight 6 if it matters. Thanks again..........