Quote
This is how it looked not long after I got it.
On 32x11.5's

[Linked Image]


Here is the look the day before my axle swap.
On 33x10'5 BFG's w BJ spacers and rear AAL

[Linked Image]

Here is the Post SAS shot sitting next to my grocery getter.
New 35x12.5 BFG's w/TG 4" SAS and rear kit.

[Linked Image]

Then we have my only poser shots after the SAS. This was the "here is a good place to stop and see if anything rubs" shot. I just need to time to do some actual wheeling.

5.29's Tru-Trac rear w/ Lock-right front
4" Trail Gear SAS elim kit up front.
4" Trail gear rear kit.
Home built winch bumper w/Warn XD900i.
Home built 1.5" body lift + Poly body mounts.
Using the 12" TG slip yoke on my front drive shaft.
SAS thread on a local board

[Linked Image]

[Linked Image]

Need to trim 2" off my bump stops for more compression travel now that I swapped the Poly-"may as well be steel" bump stops for softer rear OE bump stops up front.



can someone please tell me where I can get a bumper like this?? It looks great??????????? I see this is custom made, but is there anyplace that sells one close to it?

Last edited by drewdaddy; 03/20/07 04:23 AM.
88 P/U EFI 4x4... Stock for now.. 05 Corvette MN6 Z51 Package