So while i was out in the garage tonight working on getting my disc brake conversion to work (still doesnt)I noticed that the rotor was wobbling a little bit on the driver's side. I figured it was dirt and crud behind it so i pulled it off and wire wheeled the mounting surface which did not help the wobbling at all. After using a level to judge the amount of bent it is, there is about 1/16" of actual side to side motion. After all this i thought id check the other side as well...yup, same with that side. Has anyone ever had 2 bent axles?? I havent ever jumped this truck but I dont know about the PO. Could a bent rear housing make the shafts look like they are wobbling?

I am at a loss as to how this would happen!

Thanks!