Ok well i got a new battery installed it after haveing the old 1 out for a couple hours to reset the computer. So far so good. The first time I started it though it I was having a problem with it increasing RPM'S. If I just touched the gas to rev it up a touch it would keep going up to around 3000 rpm amd stay there for about 4-5 seconds then start to come down. The other thing was I could not keep the rpm needle at a steady rpm with my foot, it ould jump all around. I would try to keep the needle on say 2000 rpm by pressing the gas peddle but I could not do it. It would just go up and down. I don't mean that I wanted it to stay excactly on the button but just pretty close and I could not get it any where even close. Then after driving it for awhile I shut it off started it back up and everything was fine. If I hit the gas the rpm gauge would go up to about 2000 rpm and come right back down. I could get it to hold right at 2000 rpm with the foot pedal no problem. Weird. What would affect the way the throttle acted as far as getting it to stay at a steady rpm if i wanted it to?