Well i got one of my buddies to help me yesterday and we have done some clutches in honda civics and we would just lay under it and bench press it out of the car so we figured we would try that. So with it still on jacks, we both got up under it and we could lift it and move it around and we got it to rotate 90 degrees like it needs to be for my tranny and we got it to move back as far as it would go. The input shaft is still hung inside the pressure plate fingers and the bellhousing is hitting on the pressure plate but we ran out of time so we just left it on jacks for the night. It will not move back any farther than what we have it now. Should I be able to change it where it is or am I going to have the take off the pressure plate and slide it back into the bellhousing some and drop it down and out?