Tightening The Crank Bolt

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Tightening The Crank Bolt [Re: ACES_HI] #774246 12/22/06 02:32 PM

Joined: Jan 2004

Posts: 383

Southern California

Stevie

Mudrunner

Never had a problem tightening, but when it came to loosening (with the engine removed), used a beveled piece of wood jammed against the belt & pulley. It held enough to loosen: should hold enough to tighten. Good luck.

'80 4X4 Longbed

Entire Thread
Subject	Posted By	Posted
Tightening The Crank Bolt	casper3t	12/22/06 01:37 AM
Re: Tightening The Crank Bolt	4WD22R	12/22/06 01:55 AM
Re: Tightening The Crank Bolt	cktoy	12/22/06 05:22 AM
Re: Tightening The Crank Bolt	Snowtoy	12/22/06 09:05 AM
Re: Tightening The Crank Bolt	ACES_HI	12/22/06 02:12 PM
Re: Tightening The Crank Bolt	Stevie	12/22/06 02:32 PM
Re: Tightening The Crank Bolt	foxtrapper	12/22/06 12:26 PM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.458s Queries: 16 (3.455s) Memory: 0.6029 MB (Peak: 0.6359 MB) Data Comp: Off Server Time: 2026-06-09 10:19:50 UTC
Valid HTML 5 and Valid CSS