http://rides.webshots.com/photo/2124851480042310107gMlKlu

Today just did the Tach mod for the 3.4 swap. All it took was to solder a 10k ohm resistor on the PCB (printed circuit board) behind the tach gauge. The ORS harness that I used for the swap already had the wiring in place to run the tach. Just needed to modify the tach to work with the new ignitor signal.

Very easy mod. Took just under an hour from start to finish. I just put the resistor in place like the picture in the link above. Resistor cost about $2.00 for a package of 5 at Radio Shack.

1995 4Runner Limited V6 3.4 Liter 5 Speed 4x4
1995 4Runner V6 Auto 2WD