Cleaning Head, Bolts, and Engine Parts

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Cleaning Head, Bolts, and Engine Parts [Re: CJM] #777415 01/06/07 04:29 AM

Anonymous

Unregistered

Quote

You could also have it hot tanked, assuming your machine shop has a setup for aluminum.

actually is called "cold tanking" for aluminum .

for the smaller parts I use glass beads as stated above .

Where would I find glass beads?

Entire Thread
Subject	Posted By	Posted
Cleaning Head, Bolts, and Engine Parts	Anonymous	01/05/07 05:17 AM
Re: Cleaning Head, Bolts, and Engine Parts	Volcom	01/05/07 08:06 PM
Re: Cleaning Head, Bolts, and Engine Parts	Anonymous	01/05/07 10:08 PM
Re: Cleaning Head, Bolts, and Engine Parts	dcg9381	01/05/07 11:32 PM
Re: Cleaning Head, Bolts, and Engine Parts	CJM	01/06/07 01:42 AM
Re: Cleaning Head, Bolts, and Engine Parts	Anonymous	01/06/07 04:29 AM
Re: Cleaning Head, Bolts, and Engine Parts	KiwiCowboy	01/06/07 05:11 AM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.427s Queries: 16 (3.425s) Memory: 0.6016 MB (Peak: 0.6346 MB) Data Comp: Off Server Time: 2026-06-01 06:58:10 UTC
Valid HTML 5 and Valid CSS