Quote
Thanks, found it on the drivers side. I got to thinking, usually when a resistor goes out don't you have dead spots in fan switch? Mine runs in low no matter what position you set it on. Should I be looking for something else?
It's not one resistor... the resistor pack contains 3 resistors connected in series with taps for each fan speed. High speed bypasses all three resistor which is why the fan only runs in that speed when one fails. In your case it sounds like the actual switch may be bad since you say the fan runs at the same speed regardless of switch position.

Steve

'97 Rodeo 5spd. 3.2L SOHC V6 4WD