hello all,

I am in the process of replacing my front wheel bearings, but for the life of me I can't seem to get the bearing races out of the hub. I have tried pounding them out with no luck and i have also tried a slid hammer w/ reverse claw on the end with no luck. I thought about using a heat gun, but was concerned that I might heat it up to much and warp the hub. Any ideas on how to get the races out of the hub?

Thanks
Chris

1994 Montero SR 101,000 JDM 3.5
2" BL, 2.5" Valley Springs Rear Coils
BFG's 33x12.5 MT