Quote
If you don't add some kind of current limiting resistor you will burn up the LED.


Here is my setup, on the rear of the flatdeck goes a pair of incandescent oval tail light.

On the camper itself will have a pair of 4¿ round led tail light.

So when camper is mounted on the truck, should I run the led tail light from my trailer wiring already hooked to the tail lights?

or should I tap the wires directly to the original tail light wiring?

As for the LED lights, how do I know how much current limiting device should I install? What do they look like?

Thanks

91-22re(408xxxkm & counting with a rebuilt long block)- Flatbed/Camper
/33x10.5BFG-AT/Open 4:88/1.5"BJS/
+2"Shackles/Add-a-Leaf/AirLift/Dual-Batteries