Head Thickness?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Head Thickness? [Re: GPN] #785869 03/10/07 03:35 PM

Joined: Jun 2006

Posts: 73

Pensacola, Fl

bodo

Getting the Wheeling Fever

Quote

I have not found the min. hieght of a head yet, however on LC Eng's site they give the stock head and block deck hights, thickness. I found out that mine has been shaved .050" so now I'm in looking for a .050 "head Saver" shim, I would think that Fel-Pro makes one. In the morning I will measure the block.

That seems like alot since your average head milling is about .010. Why so much?

Entire Thread
Subject	Posted By	Posted
Head Thickness?	racerfan120	02/03/07 03:59 AM
Re: Head Thickness?	GPN	03/05/07 05:55 AM
Re: Head Thickness?	KiwiCowboy	03/10/07 06:51 AM
Re: Head Thickness?	bodo	03/10/07 03:35 PM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 8.201s Queries: 16 (8.199s) Memory: 0.5969 MB (Peak: 0.6299 MB) Data Comp: Off Server Time: 2026-06-07 10:55:57 UTC
Valid HTML 5 and Valid CSS