I am 99% done. I am stuck on one part, just need the bolts. I bolted the axle in, the shocks, the panhard bar, rims and tires. The e brake cables were the same length and size and fit right where the old ones went. I put in the gen2 coils too. It sits under its own power now. I am not going to get spacers in the front. You cant tell unless you are looking for it. The gen2 front rims sit in compared to the rear too, stock. I reused the arm bushings, the 95s were different.

The 1% that is not done. I need to bleed the brakes and bolt up the shaft. About the shaft. 1 thing I did not think of is, the 95 drive shaft bolts are bigger than the gen1. I may pull 4 from my Toyota until I can get some new ones. I used the U-joint and flange from the 95 and put the U-joint into the gen1 shaft. The caps were the same diameter, very small height difference. I can get some comparo pics of the ujoints at a later date. Also need to fill diff with new oil.

I have some pics. I need to resize them and upload them. Pics in a little while.