best advice i've ever received is to disconnect your wiring harness at the ecu, and pull the whole harness out with the engine and swap the harness over out of the truck where you have better access and light. you access it behind the kick panel on the passenger side.

as for pulling the engine without the tranny i have had good luck unbolting the 4 bolts that hold the trans crossmember, support it with a floor jack and lower as much as possible to access the bellhousing bolts staceman mentioned with a gaggle of extensions on your ratchet....my $.02

Last edited by brentox; 02/15/07 01:14 AM.