Spence,

Funny you should ask this week! I had to put it down for a few months due to extreme heat but picked it back up today. I took the Ranger flywheel, Montero flywheel, a brand new Montero clutch kit and new Ranger clutch kit to the machine shop to get the Ranger flywheel drilled for the Montero clutch and the pilot bearing pressed. It should be ready by next weekend.

I need to change the rear main seal on the engine and get the power steering hose fabricated. That should wrap up the fabrication pieces and I can drop the motor in.

Actually, I still need to sort out the accelerator cable. I may end up getting some fabrication done to the Montero bracket and connector on the cable to fit the throttle on the injection pump.

-Pmontero