It takes about 30min to an hour to replace the entire unit. Take the plastic molding off from the inside, pop the window out. Put the replacement in, use the string technique (desribed above) to get the gasket to pop out. It will save you the money of a window shop, but if you need the peace of mind go ahead and take it in and get it done. I actually replaced the back window, and took off my deformed rear bumper in an hour.

88 Raider(Red):160k-Reman'd 2.6-5spd-Weber-SW Hubs-34x9.5 TSL-OffRd Pkg-1"Tbar-2"BL-CB
88 Raider(Silver):No 2.6/Bad KM145 Parts/Project
88 Montero(Brown):No 2.6,4.88s Parts/Project

[b]4X4 STICKERS,SHIRTS,ETC:
4WD Stickers AT COST.[b]