|
|
|
|
 Brake Warning Light Staying On
#800171
03/25/07 06:13 PM
|
Joined: Dec 2005
Posts: 8
OP
Need a Spot
|
I have a 90 Isuzu Spacecab 4wd,I have restored the truck.replacing and rebuilding many parts.The brake system is completely redone,I have bled the system several times so ther is no air,but I can't get the warning light in the dash to go out.Is there something that has to be reset on these trucks?thks for any help.
|
|
 Re: Brake Warning Light Staying On
[Re: toosexxy]
#800172
03/26/07 10:22 AM
|
Joined: Apr 2003
Posts: 1,994
Body Damage is Cool
|
couple quess's here.
do you have the low pressure switch and low fluid switches plugged in correctly?
Is this the same light as the e-brake light.
not sure if these pertain to yours our not,though.
|
|
|
Re: Brake Warning Light Staying On
[Re: Bansil]
#800173
03/26/07 01:17 PM
|
Joined: Dec 2005
Posts: 8
OP
Need a Spot
|
Yes I do believe that it is the same light,the e-brake light.I checked the e-brake and it wires are hooked up and the switch appears to be working.The other 2 sensors I am not sure about don't think I have had them unhooked,but who knows might have been that way when I got it.I will have to check them thks
|
|
|
Re: Brake Warning Light Staying On
[Re: toosexxy]
#800174
03/27/07 01:23 AM
|
Joined: Sep 2003
Posts: 1,214
Body Damage is Cool
|
HAVE YOU CHECKED THE DIAPHRAM IN THE BRAKE MST CYL CAP IT THE RUBBER DIAP, POPS DOWN IT WILL TURN THE LITE ON , JUST PUSH IT BACK IN THE CAP UNTILL IT IS FLAT AND SEE IF THE LIGHT GOES OUT . JERRY
|
|
|
Re: Brake Warning Light Staying On
[Re: JLEMOND]
#800175
03/27/07 01:23 PM
|
Joined: Dec 2005
Posts: 8
OP
Need a Spot
|
Can't say I looked there before,but I will look and see,tks for the info
|
|
|
Re: Brake Warning Light Staying On
[Re: toosexxy]
#800176
03/27/07 11:12 PM
|
Joined: Jun 2003
Posts: 156
Wheeler
|
not trying to thread jack you but i have a 95 rodeo with the brake light always on and the rear anti lock light always on. i know i have a sticking rear caliber. what causes this? its off when i start the truck but 1 min later they pop on.
95 rodeo 3.2 liter 5 speed 4 wheel drive. 2" lift. poly bushings. 2 1/4 manderal bent exhaust flow master muff. asin manual hubs, relocated ball joints, custom air intake system
92 rodeo 3.1 2wd auto (wifes)
|
|
|
Re: Brake Warning Light Staying On
[Re: rodeo157]
#800177
03/28/07 01:05 AM
|
Joined: Apr 2004
Posts: 310
Mudrunner
|
not trying to thread jack you but i have a 95 rodeo with the brake light always on and the rear anti lock light always on. i know i have a sticking rear caliber. what causes this? its off when i start the truck but 1 min later they pop on. probably the unequal hydraulic line pressure caused by your sticking caliper. in any case, you will want to take care of that lest you risk overheating the whole wheel brake assembly. have you seen how hot it gets? //bc
1992 sohc trooper 3.2l v6 automatic . . . as is
i love a good intermittent electrical challenge. . .especially when it's someone else's.
|
|
|
Re: Brake Warning Light Staying On
[Re: trooperbc]
#800178
03/28/07 02:22 AM
|
Joined: Jun 2003
Posts: 156
Wheeler
|
its not bad, but when i put new pads on it took alot of force to get that piston back in and the other side was easy, also it makes a horrable noise in reverse
95 rodeo 3.2 liter 5 speed 4 wheel drive. 2" lift. poly bushings. 2 1/4 manderal bent exhaust flow master muff. asin manual hubs, relocated ball joints, custom air intake system
92 rodeo 3.1 2wd auto (wifes)
|
|
|
Re: Brake Warning Light Staying On
[Re: rodeo157]
#800179
03/28/07 07:07 AM
|
Joined: Apr 2004
Posts: 310
Mudrunner
|
....when i put new pads on it took alot of force to get that piston back in and the other side was easy... that could very well mean that the brake hose to the caliper on that side is clogged up, which will keep the pad from releasing... i wouldn't let it go.... //bc
1992 sohc trooper 3.2l v6 automatic . . . as is
i love a good intermittent electrical challenge. . .especially when it's someone else's.
|
|
|
Re: Brake Warning Light Staying On
[Re: trooperbc]
#800180
03/28/07 04:55 PM
|
Joined: Jun 2003
Posts: 156
Wheeler
|
im going to fix it, i just need a couple weeks to save up for it. its like 80 for the caliper. and right now im in school and only working part time. so ill replace it in about a week to 2 weeks and see what happens.
95 rodeo 3.2 liter 5 speed 4 wheel drive. 2" lift. poly bushings. 2 1/4 manderal bent exhaust flow master muff. asin manual hubs, relocated ball joints, custom air intake system
92 rodeo 3.1 2wd auto (wifes)
|
|
|
|
|
|
