ICM harness connector on SOHC V6

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

ICM harness connector on SOHC V6 #803938 04/09/07 04:27 PM

Joined: Jan 2006

Posts: 10

Charlotte,NC

a1966f100

Need a Spot

The 3 harness connectors on the ignition control module (top rear of intake) on my 1997 Rodeo are loose causing no starts and cut offs. I've tried tightening the individual terminals and retaping the harness just behind the connectors but I still don't get a tight connection. I can start the engine and barely flex the harness at the ICM and it dies. Has anyone else seen this? Can I get a new harness or connectors?

Thanks!!!

19644speed

Entire Thread
Subject	Posted By	Posted
ICM harness connector on SOHC V6	a1966f100	04/09/07 04:27 PM
Re: ICM harness connector on SOHC V6	TrailMystic	04/09/07 10:49 PM
Re: ICM harness connector on SOHC V6	SteveV	04/12/07 04:17 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.481s Queries: 15 (3.479s) Memory: 0.5947 MB (Peak: 0.6277 MB) Data Comp: Off Server Time: 2026-06-18 18:18:10 UTC
Valid HTML 5 and Valid CSS