98+ Gen 2 rear axle shaft

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: 98+ Gen 2 rear axle shaft [Re: Locomigo] #806478 04/18/07 09:02 PM

Joined: Sep 2000

Posts: 4,277

Winston-Salem, NC, USA

RobG

Roll Me Over

right, the retaining flange doesn't just bolt to the outside of the axle, but kinda slips down in the tub with a real tight, almost interference like fit. This is what builds up rust and can make it really tough to pull the shaft off. Once you break the rust free, the flange will start to slide out of the tube a good inch or so and then the shaft will be free.

-Rob

Entire Thread
Subject	Posted By	Posted
98+ Gen 2 rear axle shaft	Locomigo	04/18/07 06:38 PM
Re: 98+ Gen 2 rear axle shaft	RobG	04/18/07 06:51 PM
Re: 98+ Gen 2 rear axle shaft	Locomigo	04/18/07 06:55 PM
Re: 98+ Gen 2 rear axle shaft	RobG	04/18/07 09:02 PM
Re: 98+ Gen 2 rear axle shaft	randii	04/19/07 06:02 AM
Re: 98+ Gen 2 rear axle shaft	Locomigo	04/19/07 06:22 AM
Re: 98+ Gen 2 rear axle shaft	Bigpoppax2	04/20/07 02:44 PM
Re: 98+ Gen 2 rear axle shaft	CPOM	04/22/07 05:47 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.444s Queries: 16 (3.442s) Memory: 0.6084 MB (Peak: 0.6414 MB) Data Comp: Off Server Time: 2026-06-01 23:01:35 UTC
Valid HTML 5 and Valid CSS