98+ Gen 2 rear axle shaft

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: 98+ Gen 2 rear axle shaft [Re: Locomigo] #806481 04/20/07 02:44 PM

Joined: Apr 2002

Posts: 2,529

Bluefield, Virginia

Bigpoppax2 Offline

Roll Me Over

I had to end up renting a slide hammer to get mine out when I did my locker. They were a bit stubborn even with the slide hammer. Once they had a few good hits though, they slid right out.

Joe

A gun in the hand is better than a cop on the phone.

98 Passport 33's, Supercharged, Calmini Bumper, rockbars, diff drops, Teralows, 4.77's, Aussie and ARB lockers, Safari snorkel, Optima red top.

Entire Thread
Subject	Posted By	Posted
98+ Gen 2 rear axle shaft	Locomigo	04/18/07 06:38 PM
Re: 98+ Gen 2 rear axle shaft	RobG	04/18/07 06:51 PM
Re: 98+ Gen 2 rear axle shaft	Locomigo	04/18/07 06:55 PM
Re: 98+ Gen 2 rear axle shaft	RobG	04/18/07 09:02 PM
Re: 98+ Gen 2 rear axle shaft	randii	04/19/07 06:02 AM
Re: 98+ Gen 2 rear axle shaft	Locomigo	04/19/07 06:22 AM
Re: 98+ Gen 2 rear axle shaft	Bigpoppax2	04/20/07 02:44 PM
Re: 98+ Gen 2 rear axle shaft	CPOM	04/22/07 05:47 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.429s Queries: 16 (3.426s) Memory: 0.6082 MB (Peak: 0.6412 MB) Data Comp: Off Server Time: 2026-05-31 16:57:56 UTC
Valid HTML 5 and Valid CSS